(818) 282-5846

CALL FOR IMMEDIATE SERVICE!

15150 Roxford St 406

Sylmar, CA 91342

Do It Yourself Water Heater Repair Recommendations in West Hills

Presume you are looking for qualified Water Heater Repair in West Hills. Because case, we have an excellent group of skilled plumbings who can rapidly detect the source of the problem and get it repaired fast so that you can return to enjoying a stress-free life, with ensured fulfillment from the extremely first call.

Nevertheless, If you plan to take the danger of performing a Water Heater Repair in West Hills by yourself, these are some standard steps to do so:

Shut down the supply of water to the water heater, shut down the electrical power, have an electrical water heater, or the gas source if you have a gas water heater.

Drain the water from the water heater tank by opening the valve at the bottom of the tank near the flooring. It might be helpful to connect a garden tube to the drain valve and run it to a close-by drain to avoid a huge mess.

As soon as the tank is empty, you can disconnect the gas line, flue pipe, and water lines for a gas water heater or the power wires and water lines for an electrical water heater. The water heater may still be a little heavy, so you might wish to use a dolly to remove it from your home.

When it runs out the way, tidy up the area to make it set for the brand-new water heater. When the website is prepared, you can set the new unit in place and start reconnection of the water lines, the gas or electric supply, and the flue pipe for the gas water heater. Ensure that you check your gas line joints with soap bubbles for gas leakages when it comes to a gas water heater.

Turn the gas/power on and begin filling up the water tank. For the gas water heater, you have to also remember to lighten the pilot burner. You also want to make certain that the thermostat is set to the temperature that you want, the most common setting is 120 degrees Fahrenheit. At this moment, your new water heater should be set to go.

Changing a Water Heater Valve

Water may well likewise leakage from the pressure relief valve on the water heater. This could be triggered by either a malfunctioning valve or a high-pressure circumstance in the water heater. If the valve itself is bad, it can be replaced in several actions:

Shut off the water heater, turned off the water system and drain some of the water from the tank.

Lift the little lever on the valve to discharge any remaining pressure.

Utilize a wrench to loosen the valve from the tank and replace it with a brand-new valve.

Usage Teflon tape on the threads of the brand-new valve prior to you screw it into the water heater.

You must then be safe to re-fill and turn the water heater back on. Most other leaks you may experience are repaired by tightening up loose valves or fittings on the water heater and the interconnected pipes.

What to Do When You Have an Issue With Your Tank Water Heater in West Hills
Common Water Heater Problems in West Hills

Best Plumber in Sylmar CA

Recent Post

Our Coupons