(818) 282-5846

CALL FOR IMMEDIATE SERVICE!

15150 Roxford St 406

Sylmar, CA 91342

Do It Yourself Water Heater Repair Recommendations in Stevenson Ranch

Imagine you are looking for qualified Water Heater Repair in Stevenson Ranch. Because case, we have a fantastic team of skilled plumbers who can immediately diagnose the source of the problem and get it fixed fast so that you can return to enjoying a stress-free life, with ensured satisfaction from the actual first call.

However, If you aim to take the danger of carrying out a Water Heater Repair in Stevenson Ranch on your own, these are some standard actions to do so:

Shut off the water system to the water heater, shut down the electrical power, have an electric powered water heater, or the gas supply if you have a gas water heater.

Drain the water from the water heater tank by opening the valve at the bottom of the tank near the flooring. It might be practical to fasten a garden pipe to the drain valve and run it to a close-by drain to avoid a big mess.

Once the tank is empty, you can detach the gas line, flue pipe, and water lines for a gas water heater or the power wires and water lines for an electric water heater. The water heater may still be a little heavy, so you might wish to use a dolly to remove it from your home.

When it is out of the method, tidy up the area to make it prepared for the new water heater. Once the site is prepared, you can set the new unit in place and start reconnection of the water lines, the gas or electrical supply, and the flue pipe for the gas water heater. Make sure that you look at your gas line joints with soap bubbles for gas leaks in the case of a gas water heater.

Switch the gas/power on and begin refilling the water tank. For the gas water heater, you must absolutely also remember to light up the pilot burner. You likewise wish to ensure that the thermostat is set to the temp that you want, the most typical setting is 120 degrees Fahrenheit. At this point, your brand-new water heater need to be set to go.

Substituting a Water Heater Valve

Water may well likewise leakage from the pressure relief valve on the water heater. This could be brought on by either a defective valve or a high-pressure scenario in the water heater. If the valve itself is bad, it can be changed in a number of actions:

Shut off the water heater, shut down the water supply and drain some of the water from the tank.

Lift the little lever on the valve to release any remaining pressure.

Use a wrench to loosen the valve from the tank and change it with a new valve.

Use Teflon tape on the threads of the new valve prior to you screw it into the water heater.

You ought to then be safe to refill and turn the water heater back on. Most other leaks you may encounter are fixed by tightening up loose valves or fittings on the water heater and the connected pipes.

Indications You Need a Water Heater Repair in Stevenson Ranch
Hot Water Heater Repair Near Me in Stevenson Ranch

Best Plumber in Sylmar CA

Recent Post

Our Coupons