(818) 282-5846


Service Area

Los Angeles, CA

Best Plumber in Sylmar CA

Do It Yourself Water Heater Repair Recommendations in Northridge

water heater repair in canoga park

Intend you are looking for professional Water Heater Repair in Northridge. In that case, we have a fantastic team of experienced plumbers who can rapidly detect the source of the issue and get it repaired quick to ensure that you can get back to taking pleasure in a stress-free life, with warranted fulfillment from the extremely first call.

Nonetheless, If you plan to take the risk of carrying out a Water Heater Repair in Northridge on your own, these are some basic procedures to do so:

Turn off the water supply to the water heater, turned off the electrical power, have an electrically powered water heater, or the gas source if you have a gas water heater.

Drain the water from the water heater tank by opening up the valve at the bottom of the tank near the floor. It may be handy to fasten a garden pipe to the drain valve and run it to a neighboring drain to avoid a huge mess.

Once the tank is empty, you can detach the gas line, flue pipe, and water lines for a gas water heater or the power wires and water lines for an electric water heater. The water heater may still be a little heavy, so you might wish to utilize a dolly to remove it from your home.

When it is out of the method, clean the area to make it all set for the brand-new water heater. When the website is prepared, you can set the brand-new unit in place and start reconnection of the water lines, the gas or electrical supply, and the flue pipe for the gas water heater. Make certain that you look at your gas line joints with soap bubbles for gas leaks when it comes to a gas water heater.

Turn the gas/power on and start refilling the water tank. For the gas water heater, you must definitely likewise remember to lighten the pilot burner. You likewise wish to ensure that the thermostat is set to the temperature that you desire, the most typical setting is 120 degrees Fahrenheit. At this moment, your new water heater need to be set to go.

Switching Out a Water Heater Valve

Water may also leak from the pressure relief valve on the water heater. This could be brought on by either a faulty valve or a high-pressure situation in the water heater. If the valve itself is bad, it can be changed in numerous actions:

Shut down the water heater, shut down the water supply and drain some of the water from the tank.

Raise the little lever on the valve to release any remaining pressure.

Use a wrench to unscrew the valve from the tank and replace it with a new valve.

Use Teflon tape on the threads of the new valve before you screw it into the water heater.

You must then be safe to fill up and turn the water heater back on. A lot of other leakages you may encounter are repaired by tightening up loose valves or fittings on the water heater and the linked pipelines.

Usual Water Heater Difficulties in Northridge

Best Plumber in Sylmar CA

Recent Post

Our Coupons