Expect you are looking for expert Water Heater Repair in Woodland Hills. Because case, we have a great group of experienced plumbers who can quickly identify the source of the problem and get it fixed quickly to ensure that you can return to enjoying a hassle-free life, with guaranteed fulfillment from the very first call.
However, If you plan to take the threat of carrying out a Water Heater Repair in Woodland Hills by yourself, these are some standard measures to do so:
Shut off the water supply to the water heater, turned off the electrical power, have an electric powered water heater, or the gas supply if you have a gas water heater.
Drain the water from the water heater tank by opening the valve at the bottom of the tank near the floor. It may be handy to connect a garden hose to the drain valve and run it to a nearby drain to avoid a huge mess.
Once the tank is empty, you can detach the gas line, flue pipe, and water lines for a gas water heater or the power wires and water lines for an electrical water heater. The water heater might still be a little heavy, so you might wish to use a dolly to remove it from your house.
When it is out of the way, clean the area to make it ready for the brand-new water heater. Once the website is prepared, you can set the brand-new system in place and start reconnection of the water lines, the gas or electric supply, and the flue pipe for the gas water heater. Make certain that you look at your gas line joints with soap bubbles for gas leakages in the case of a gas water heater.
Switch the gas/power on and begin refilling the water tank. For the gas water heater, you must also remember to light the pilot burner. You likewise wish to make certain that the thermostat is set to the temperature level that you desire, the most typical setting is 120 degrees Fahrenheit. At this moment, your new water heater ought to be set to go.
Switching Out a Water Heater Valve
Water might also leak from the pressure relief valve on the water heater. This could be caused by either a defective valve or a high-pressure scenario in the water heater. If the valve itself is bad, it can be replaced in a number of actions:
Shut down the water heater, shut off the water supply and drain some of the water from the tank.
Raise the little lever on the valve to release any staying pressure.
Utilize a wrench to unscrew the valve from the tank and replace it with a brand-new valve.
Usage Teflon tape on the threads of the new valve before you screw it into the water heater.
You must then be safe to fill up and turn the water heater back on. A lot of other leakages you might encounter are repaired by tightening up loose valves or fittings on the water heater and the linked pipes.